This page as an PDF-Document? Click on that Symbol and wait a little moment... --->

All settings of the MikoKopter can be made via the KopterTool.
Normally you have only to set a few basic settings for channel selection. After that the copter is ready to fly.
But also a fine tuning can be done here.

Overview

If you open the Settings of the MikroKopter Tool you can see the most important settings at a glance.
(see picture above right)

For easy overview the settings window is divided into different areas:

The tab pages

At the upper part of the settings the tabs are located. If the settings have been opened for the first time, the following tabs are available: Channels, Camera, Output and Easy Setup.

With these four tabs you can configure the most important settings quickly and easily.
If you will see all tabs, click on Experte view.

The middle section

In the middle part you can set different parameter (depending on the selected tab).
Here we see the tab Easy Setup / Setting 3 Easy.

The "Channel Quick View"

On the transmitter you can set for each channel a switch, push button or potentiometer. If you now move a switch, push button or potentiometer you can directly see which channel is working.

The Parameterset

In the bottom bar you can writing, reading etc. the set parameters.

• 

  • Closes the setting window.
    INFO: If Changes were not transferred to the copter and you closes the window,
    a confirmation screen appears :
    

• 

  • Opens the appropriate wiki website with the description of the settings for the open page.

• 

  • Reads the current settings of the open settings from the copter.

• 

  • Writes the settings in the copter.

• 

  • Saves the current settings of the open setting on the PC.

• 

  • Loading a saved Settings on the PC .

• 

  • Resetting of the open setting to factory default.

• 

  • Selects one of the 5 settings.

    In total 5 settings are available. Each setting can also be set individually.
    The settings are:

    • Setting 1 = Fast (Sporting flight attitude)

    • Setting 2 = Agile (Agile flight attitude)

    • Setting 3 = Easy (Basic flight attitude)

    • Setting 4 = Easy (Basic flight attitude)

    • Setting 5 = Easy (Basic flight attitude)

• Each setting can be assigned to an individual name.
  

• To select the settings with the transmitter the proceed as follows:
  

  • Setting 1 => Roll left + Nick middle plus Gas up + Gier left
    

  • Setting 2 => Roll left + Nick up plus Gas up + Gier left
    

  • Setting 3 => Roll middle + Nick up plus Gas up + Gier left
    

  • Setting 4 => Roll right + Nick up plus Gas up + Gier left
    

  • Setting 5 => Roll right + Nick middle plus Gas up + Gier left
    

Info

• KategorieTools