Channels

The Transmitter will transmit to the Mikrocopter on the assigned 4 channels
needed by the Mikrocopter: GAS, GIER, NICK, ROLL

MotorSafetySwitch

In the past it happened that users switched off the MK during flight by moving the gas/yaw stick into the left corner. Especially in the vario-altitude control mode that could happen

Now this can be avoided via a seperate channel.

On/off is disabled if the value of this channel is below 35

Tip: you can put this onto the channel of the altitude controller. So you can't switch off with enabled hight-control

Using the other channels

The other 4 Channels can be assigned to POTI 1,2,3 or 4
On each of the POTI a channel can be assigned to control various functions from a switch or potentiometer to control height, camera panning, tilt etc.

Display of the Channels

The display above shows the current value of the individual channels.