/All /Altitude /CamCtrl /Camera /Channels /Configuration /Coupling /Easy Setup /Easy-SETUP /Gyro /Looping /Misc /Mixer-SETUP /Navi-Ctrl /Navi-Ctrl 2 /Output /Stick /User |
Looping
Important: To get to this settings-tab, the Alt-key must be pressed when clicking on Settings in MK-tool.
Arrows: Loops in the corresponding direction. Looping will only be possible in the red-arrowed directions.
Gas Limit: This throttle-value (K=) will set through loop (as an upper limit).
Response threshold: Defines the roll/nick stick-value at which the loop is initiated.
Hysteresis: Stick-Hysteresis for Response Threshold. Usually always lower than Response Threshold. External article on Hysterisis.
Important: Response Threshold - Hysteresis should always be between 20-40 , else wise the MK will bank to the current stick-input very quickly (especially true if setup for acrobatics and touchy controls), when the looping-function is completed (potentially requiring a large stick-input, that could initiate another loop).
TurnOver Nick: Defines how many degrees the MK should rotate during a loop in the backwards/forwards direction. 100 means 360 degrees. If the MK rotates too far, this value must be decreased. 1 = 3,6 degrees.
TurnOver Roll: same as TurnOver Nick, but for the roll-axis.
Note: The looping-functionality is only used when flying using the accelerometers (no tick in "Heading Hold").