Step 3 - Connect the Kopter with the PC |
||
|
|
Wikiseite vor |
Step 3 - Connect the Kopter with the PC
Requirement
Step2 has been read.
Connect Kopter with PC
Is the KopterTool and the MK-USB installed and set up there is now a good time to connect the Kopter over the MK-USB to your PC/Laptop.
Here now you need to connect right in polarity the ribbon cable to the MK-USB and the FlightCtrl (or another module).
If you connect the ribbon cable in a wrong way you may be damage the boards.
Two things you should know:
On ALL boards is on the TOP-side and on the right next to the pin-header a "1" printed.
The ribbon cable has on one side a red mark.
The red mark should point to the printed "1".
Wether or not if you have connected only the FlightCtrl or already the GPS-System, the connection to the Kopter looks in that way:
Example photo: Connection to FlightCtrl |
Example photo: Connection to NaviCtrl |
The jumper on the MK-USB has to be open.
Everything OK? Then it continues here: 