#acl AdminGroup:read,write,revert Brunweil:read,write,revert All:read

{{{#!wiki MK_Nav
||||||<class="MK_Nav_Header">Step 1 - Kopter-Check||
||<class="MK_Nav_left">||<class="MK_Nav_middle">[[fr/Erstinbetriebnahme/Help|{{attachment:symbols/Help.png}}]]||<class="MK_Nav_right">Wikiseite vor [[fr/Erstinbetriebnahme/Step2|{{attachment:symbols/Pfeil_rechts.png}}]]||
}}}

{{{#!wiki MK_select1

 * {{http://mikrokopter.de/images/deu.gif}} [[Erstinbetriebnahme/Step1|deutsch]]
 * {{http://mikrokopter.de/images/eng.gif}} [[en/Erstinbetriebnahme/Step1|english]]
}}}


##include_step_begin

= Step 1 - Kopter-Check =

Before the Kopter will be powered up the first time after a successful assembly __you should review your work again__.<<BR>><<BR>>

<!> For that reason that it is an electronic model a solder bridge or an improperly connected cable __can destroy__ hours of work within seconds.<<BR>><<BR>>

What should you check? <<BR>>
Here are some hints: <<BR>><<BR>>

 * The red outrigger is pointing forward/to the front?____
 * The !FlightCtrl is mounted correctly (with the SMD parts upwards)? 
 * The !FlightCtrl is pointing with the arrow forwards to the red outrigger?
 * The propellers were properly aligned and mounted with the correct direction?____
 * All bolted connections were made correctly?____
 * Visual check of all solder joints.____
 * Visual check of all connected cables.____
 * The power distribution board has been checked for shorts? [[fr/Erstinbetriebnahme/Help#Step1-1|(Check help)]] ____
 * If you have allready mount the GPS-System, is it correct connected? [[fr/MK-Tower|(Check help)]]
<<Anchor(Step1-1)>>


<<BR>><<BR>>
Also this should be checked: <<BR>>
 * At the transmitter a model memory with a fixed-wing model (ACRO) has been set up. ____
 * The transmitter has been set to your desired MODE (MODE 2 is the regular mode).____
 * The channels on the transmitter are assiged to switches, buttons and potis.____
 * The receiver was bound with the transmitter?____
 * The receiver gives a PPM sum-signal?____
 *(or has it been changed to - i.e. necessary at the receiver of the HoTT transmitter => [[HoTT#Empf.2BAOQ-nger_auf_Summensignal_stellen|Link]])?____ 
 * The receiver is connected to the !FlightCtrl ? [[fr/Erstinbetriebnahme/Help#Step1-2|(Check help)]]
<<Anchor(Step1-2)>>

##include_step_end

<<BR>><<BR>><<BR>><<BR>>
Everything OK? Then it continues here:
[[fr/Erstinbetriebnahme/Step2|{{attachment:symbols/Pfeil_rechts.png}}]]