⇤ ← Revision 1 vom 07.05.2014 17:13
3167
Kommentar:
|
3177
|
Gelöschter Text ist auf diese Art markiert. | Hinzugefügter Text ist auf diese Art markiert. |
Zeile 71: | Zeile 71: |
[[http://mikrocontroller.com/files/BL_V3/BL-Ctrl3_MEGA168_V1_04c_SVN853.hex|V1.04c]] | Download: [[http://mikrocontroller.com/files/BL_V3/BL-Ctrl3_MEGA168_V1_04c_SVN853.hex|V1.04c]] |
Inhaltsverzeichnis
BL V3 Update
Connection
For the update, three lines must be connected between the MKUSB and the BL-Board
- RXD (Pin 1)
- TXD (Pin 9)
- GND (Pin 7 or at other GND-connection on the BL-Board)
please look onto your board, where it has the 1 marking on the pin-connections
There are different possibilities to make the connections
Solution 1
- Here the GND-Pin connection is done by a simple cable
- RXD and TXD are just held onto the board (update takes only 5-10 seconds)
- GND can be connected to any GND-Connection on the BL-Board - it doesn't have to be the GND of that specific BL that you want to update
Solution 2
Here are the Pins only bended.
Solution 3
Here two pin-connectors are put in series. That creates a very convenient connector.
Update
The Koptertool is used. The procedure is similar to the FC-Update
- Power the BL-Ctrol by a DC power supply. That is better than using a Lipo, because in case of a shortcut, it might not damage the board.
- Press 'Update'
- Select the file
- Repeat the procedure for all BL-Ctrls
- After the update, the BLs will show their current version and address
Firmware
Here you can find the latest versions:
http://mikrocontroller.com/files/BL_V3
Version V1.00
Since 1st Jan. 2014
- First Version
Version V1.02d
Since 17th March 2014
- Improved motor-start by a self-learning start phase
- internal speed limitation
increased commutating speed (Max RPM is 200.000 devided by the number of magnets -> 16.666 RPM if you have 12magnets)
- Prepared for redundant FC-Operation
Version V1.04c
since 07th May 2014
Download: V1.04c
- better protection against high current peaks during operation
- Safer behavior while operation without propellers
- Integrated watchdog that restarts the BL controllers in case of a failure
- Various bug fixes
we strongly recommend to update to version 1.04c !